How does an automatic faucet help with garden care? 🧐🧐🧐

Irrigation water is taken from the water supply.
At the entrance to the automatic irrigation system, a water meter and an electric pump are installed, depending on which hydraulic circuit is adopted. The underground highway is equipped with a check valve, eliminating the possibility of contaminated groundwater entering the system.
To remove water from the system before the onset of winter frosts, a drain hose is attached. The filter removes contaminants that may fall into the automatic irrigation system before distributing the water along the paths.
Branching at the inlet, a main valve of a special design of the solenoid type is installed, equipped with protection against water with the possibility of controlling it from the controller.
The controlled solenoid valve is mounted in a plastic housing inside the ground at the center of the line.
Each zone is created for the work of the same group of spray groups. A gearbox is installed inside the drip irrigation system. It maintains the optimum allowable water pressure in the system to form droplets. The automatic drain valve at the end of the highway eliminates the formation of increased soil moisture, which contributes to its drainage system. when the system is turned on.
The controller that controls the operation of the rain sensor allows you to stop watering during rain, to prevent its excessive.